What causes the loader parts to run off after braking
There are many loader accessories, and various parts, including easy to lose parts, belong to the loader accessories.
Such as combined instrument, loader head, loader seat, water block, ...
The common screws on the crushing hammer are the whole body bolts, splint bolts, high pressure pack fastening screws, external displacement valve fixing screws and so on. The importance of screws is no less than the key parts of the machine, because ...
Read More
White smoke
1, the white smoke is mostly caused by the cylinder water, please check the diesel inside there is no water, generally after starting the white smoke time is very short, the engine is no problem;
2. If the excavator starts white...
The micro-excavator should clean the oil tank before refueling and replacement, leaving residual oil and impurities. The residual oil retained at the bottom of the tank by the micro excavator is connected to the bottom of the 19.6 ~ 29.4kpa compresse...
Read More
1. Hydraulic unloading, convenient and time-saving;
2. Using solid tires with tapered roller bearings inside, the tires are not only wear-resistant but also able to withstand larger radial and axial forces;
3. The height of the brush is adj...
When the small crawler excavator has a jump gear, it should be stopped for inspection, find the cause, and solve the fault.
How to stop when driving on the flat road, it can be processed normally;
If there is a jump gear problem when going ...
In the cold winter, a large amount of snow will bring a lot of inconvenience to traffic, life, etc., and the snow removal equipment sweeper has shown extraordinary ability in dealing with the thick snow.
Snow removal equipment The sweeper can ef...
Assuming that the pressure relief of the upper and lower arms is not very severe, it is generally a normal phenomenon, and the upper arm is raised the highest, the lower arm and the bucket are straightened, and how much time the upper arm can fall to...
Read More
In the cold winter, I believe that many loader drivers have encountered the problem of winter loader lighting difficulties, BONOBO for you to explain the prevention of winter loader lighting difficulties.
When the loader is used in winter, after...
In the purchase process of our wheeled excavator, we need to reasonably buy our machinery and equipment, wheeled excavator manufacturers in order to reduce the investment of capital, we buy second-hand products are also very much, so what problems sh...
Read More
How to deal with the rotation error system failure of small hydraulic excavator?
1. First, disassemble the two rotary release valves around the rotary motor to improve the characteristics of the valve body and seal ring.
2. Disassemble the ...
In the past, domestic loaders commonly used No. 3 or No. 4 calcium-based grease, and now this grease can not meet the requirements of loaders working under various climates (high temperature or low temperature, wet and water, etc.), because lithium-b...
Read More
Hot News2024-09-18
2024-09-18
2024-07-03
2024-03-08
2024-03-08
2024-03-08
EN
