Mechanical grab bucket for small excavator, daily maintenance points

In various small-scale engineering operations, "mechanical grabs adapted to small excavators" play a vital role. From material handling at construction sites to vegetation transplanting in garden landscape projects, it can show its prowess. However, to ensure that the mechanical grab is always in good working condition, daily maintenance is essential. Next, let's take a closer look at the key points of its daily maintenance.

1. Inspection and maintenance of structural parts

The structural parts of the mechanical grab are its core parts and bear huge stress during the operation process. For the "connecting pins of the mechanical grabs of small excavators", their wear should be checked regularly. Due to frequent opening and closing actions, friction will occur between the pins and the sleeves. If excessive wear occurs, the grab will not open and close smoothly, affecting the operating efficiency. Generally, the pins need to be removed at regular intervals to observe whether there are obvious scratches, deformations or excessive wear on their surfaces. If problems are found, the pins or sleeves should be replaced in time to ensure the normal operation of the grab.

The bucket teeth of the grab are also structural parts that need to be focused on. When grabbing materials, the bucket teeth are in direct contact with the materials and are easily worn. "The replacement cycle of the bucket teeth of a small excavator mechanical grab" varies depending on the working environment and the nature of the material. If the operation is in a relatively soft soil environment, the bucket teeth will wear relatively slowly; but if the bucket teeth are used to grab hard materials such as ore, the wear rate will accelerate. Once the bucket teeth are found to be worn more than half, or broken, they should be replaced immediately, otherwise it will not only reduce the grabbing ability of the grab, but also cause additional damage to other structural parts.

2. Maintenance of the hydraulic system

The hydraulic system is the power source for the mechanical grab to achieve flexible opening and closing, and its normal operation is crucial to the performance of the grab. "Replacement of hydraulic oil for small excavator mechanical grab" is a key link in the maintenance of the hydraulic system. During use, the performance of the hydraulic oil will deteriorate due to oxidation, pollution and other reasons. It is generally recommended to test the hydraulic oil every certain number of working hours.

If the hydraulic oil is found to be darker in color, has impurities or the viscosity does not meet the requirements, it needs to be replaced in time. At the same time, when replacing the hydraulic oil, pay attention to cleaning the hydraulic oil tank and filter to prevent impurities in the old oil from contaminating the new oil.

The seals in the hydraulic system should not be ignored. The function of the seal is to prevent hydraulic oil leakage and ensure the stability of system pressure.

"Inspection of seals in the hydraulic system of small excavator mechanical grab" should be carried out regularly. Carefully check whether the seals are aging, deformed, damaged, etc. Once a problem is found in the seal, it should be replaced immediately, otherwise the leakage of hydraulic oil will not only cause environmental pollution, but also cause the grab to move weakly or even fail to work normally.

3. Lubrication and maintenance

Good lubrication can reduce the friction between the various parts of the mechanical grab, reduce wear and extend the service life. For "lubrication of the active joints of the small excavator mechanical grab", it should be carried out according to the prescribed cycle.

Use appropriate grease to fully lubricate the opening and closing joints, connecting pins and other parts of the grab.

During the lubrication process, ensure that the grease is evenly applied to each friction surface to avoid missing coating. In addition, in harsh working environments, such as dusty and humid construction sites, the lubrication cycle should be appropriately shortened to ensure that each active joint is always in a good lubrication state.

In summary, the daily maintenance of "mechanical grab buckets adapted to small excavators" covers multiple aspects such as structural parts inspection, hydraulic system maintenance, and lubrication maintenance.

Only by doing these daily maintenance work well can we ensure that the mechanical grab buckets can operate stably and efficiently in small excavator operations, providing strong guarantees for the smooth progress of various small projects.

Choose BONOVO for high-quality, customizable brush cutters for skid steers with fast delivery. Contact us today to discover how our superior products can enhance your land management tasks!