Maintenance and operation standards for cleaning attachments (adjustable steering angle) for skid steer loaders

DAILY INSPECTION CONTENT

Before operation, the "skid loader front broom attachment" should be visually inspected to ensure that there is no obvious structural damage, cracks or loose parts. Check whether the "broom steering angle adjustment mechanism" is flexible, and confirm that the hydraulic hose has no leakage or signs of aging.

After daily operation, the debris attached to the surface of the attachment should be cleaned, especially the broom bristles, to prevent the accumulation of foreign matter from affecting the sweeping efficiency of the "skid loader angle adjustment broom" and the balanced wear of the bristles.

REGULAR MAINTENANCE POINTS

1. Bristle maintenance

Check the bristle wear once a week according to the frequency of operation. If the length of the "skid loader cleaning bristle assembly" is found to be less than 50% of the original length, it should be replaced immediately to avoid a decrease in the cleaning effect.

2. Hydraulic system maintenance

The hydraulic system is the core of the "adjustable angle cleaning attachment" to achieve steering adjustment. Check the hydraulic oil level and oil quality every month to see if they are normal, and check whether the connection parts are firm. If leakage is found at the oil pipe joint, the seal should be replaced and the interface should be tightened.

3. Steering angle control mechanism

The "sweeping attachment with angle adjustment function for skid steer loaders" should maintain the flexibility and response speed of its angle adjustment device.

It is recommended to use the specified lubricant to lubricate the control shaft, gears, pins and other moving parts after every 100 hours of operation.

TROUBLESHOOTING AND COMMON PROBLEMS

When using the "Adjustable Angle Broom Attachment for Skid Steer Loaders", if the angle cannot be adjusted, the sweeping effect is uneven, or the attachment shakes, the following aspects need to be checked:

■ The angle adjustment hydraulic cylinder is stuck or the internal pressure is released, and it needs to be repaired or replaced;
■ The control valve or control lever responds slowly, and the electronic or hydraulic control system needs to be checked;
■ The broom fixing bracket is loose, causing the attachment to shake during use, and the connector should be reinforced in time.

MAINTENANCE CYCLE RECOMMENDATIONS

To ensure the long-term and efficient operation of the "Skid Steer Loader Front-mounted Cleaning Attachment", maintenance can be performed according to the following cycles:

■ Daily: Appearance inspection and cleaning;
■ Weekly: Brush wear inspection;
■ Monthly: Hydraulic system inspection and refueling;
■ Quarterly: Comprehensive functional test and bolt tightening review;
■ Annual: System general inspection, including bristle replacement, hydraulic pipeline replacement, etc.

SAFETY TIPS

Before performing maintenance operations on the attachments, be sure to turn off the power supply of the skid steer loader, release the hydraulic pressure, and use the support device to fix the attachment position to prevent accidental sliding and causing injuries.

Through scientific and systematic maintenance management, not only can the service life of the "adjustable angle cleaning attachment for skid steers" be extended, but also the operating efficiency and construction safety can be guaranteed. It is recommended that all operators strictly follow the above maintenance operation standards and make appropriate adjustments based on actual working conditions.

Choose BONOVO for high-quality, customizable brush cutters for skid steers with fast delivery. Contact us today to discover how our superior products can enhance your land management tasks!