Loader snow clearing operation process and maintenance

1. Connect the main engine to the included snowplow body by quickly changing the connection. The lock pin of the quick change joint must be inserted into the pin hole of the snowplow bracket. The lever must be fully pressed and locked.

2, when connecting the main body of the closed snowplow, please ensure that the contact surface is free of visible dirt and other impurities, and the connection plate is fully installed. Secondly, the closed snowplow must be lifted during the connection process. Otherwise, the bottom of the connecting plate may not be connected, so that the locking pin will not bend, resulting in a serious accident in which the closed cleaning device falls off.

3. Connect the attached hydraulic quick connector to the main engine to ensure that the quick connector is correctly positioned. When installing and removing hydraulic quick couplings, be sure to turn off the engine and use the pressure release function to release internal pressure in the lines.

4, in order to improve the service life of the motor, the motor drain pipe should be returned to the main tank as far as possible.

5, keep the right amount of snow brush, so that the cleaning effect is better. For the adjustment method, please refer to the following steps:

Move the cleaner to a flat, dirty floor.

snowplow
Rotate the brush roller at low speed to lower the cleaner to the ground and run it under working conditions for about half a minute.
Lift the snowplow to activate the brakes, turn off the power, and check for clean marks. The width of the cleaning mark should be about 150mm and the length is equal to the length of the roller brush.

If the width of the clean mark is not near the reference value, the amount of brush compaction is adjusted by adjusting bolts at both ends of the cleaner.
Be sure to adjust the adjustment bolts at both ends to prevent uneven wear on the snowplow.

6, start the equipment, so that the snow plow began to rotate, ensure that the edge of the shovel blade of the snow plow bucket is just in contact with the ground. The rear end of the bucket is lifted slightly off the ground and the engine is running while the engine is clean. For better cleaning results, try reducing the speed.

7. When starting the machine, the engine throttle should be in idle state. Use the variable flow control switch to slowly press the button and use the hydraulic impact force to achieve motor start-up protection. After running for a few minutes, the motor speed usually increases to the correct throttling state.

8, in the cleaning process, the cleaning effect of the cleaning agent should be minimized to reduce excessive wear of the brush. After a period of use, check the brush wear of the snowplow and adjust the brush compaction amount by adjusting the bolts to ensure a good cleaning effect.

9, the snow plow low speed operation, moderate speed, can better hard ground gravel. If you drive too fast, it will kick up dust and affect the operator's line of sight.

10, the process of snowplow operation and the main method of maintenance is so.

Choose BONOVO for high-quality, customizable brush cutters for skid steers with fast delivery. Contact us today to discover how our superior products can enhance your land management tasks!